This shows you the differences between two versions of the page.
Next revision | Previous revisionLast revisionBoth sides next revision | ||
hardware_-_getting_started [10/08/2019 00:43] – created dmax | hardware_-_getting_started [08/26/2020 11:43] – gfactor | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | == Work in progress | + | ===== Getting Started===== |
- | \\ | + | |
- | Content | + | This page describes the process of setting up your QORTector device. |
+ | |||
+ | * Use an Ethernet cable to attach a modem or active data jack to the Ethernet port on your Qort device. | ||
+ | * Plug in the power adapter | ||
+ | * Connect to the wireless network " | ||
+ | * In your web browser, navigate to http:// | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | * To access Qortal minting stage, SSH to portal IP address 172.24.1.1 as described on page [[hardware_-_service_access|Service Access]] | ||
+ | |||
+ | If you do not wish to access Qort device via its Wifi network, you can obtain its WAN IP address from your modem or using a simple network scan utility. Please | ||
+ | |||
+ | // |