This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
port_forwarding [01/30/2023 14:37] – gisele_h | port_forwarding [01/31/2023 05:40] – old revision restored (01/30/2023 18:11) gfactor | ||
---|---|---|---|
Line 36: | Line 36: | ||
===== More Than One Node On Your Home Network ===== | ===== More Than One Node On Your Home Network ===== | ||
- | If you have more than one node on your network, then you’ll want to disable uPnP: | + | If you have more than one node on your network, then you’ll want to: |
* Set a static IP address for each node in the router. | * Set a static IP address for each node in the router. | ||
* Configure port forwarding in the router for each node. | * Configure port forwarding in the router for each node. | ||
- | * Stop the core, then change the json settings on each node to disable uPnP. | + | * Stop the core, then change the json settings on each node to disable uPnP |
* Start the core on each node. | * Start the core on each node. | ||
- | 1) Login to your router | + | 1) Set the IP address of each node to STATIC. This will prevent the node’s IP address from changing |
- | 2) Set the IP address of each node to STATIC. This will prevent the node’s IP address from changing and affecting all of this configuration. | + | 2) Set port forwarding for each node as shown in the following. Internal and external for each node will be unique and NOT match the other nodes: |
- | + | ||
- | 3) Set port forwarding for each node as shown in the following. Internal and external for each node will be unique and NOT match the other nodes: | + | |
**Node 1** Internal: 12392 External: 12392 | **Node 1** Internal: 12392 External: 12392 | ||
Line 61: | Line 59: | ||
(Just change the last digit in each number.) | (Just change the last digit in each number.) | ||
- | 4) Stop the core by entering the following command in the terminal: | + | 3) Stop the core by entering the following command in the terminal: |
< | < | ||
Open your settings.json - this may be blank which indicates you have the default settings. You will then copy and paste the code below into the settings.json and click save: | Open your settings.json - this may be blank which indicates you have the default settings. You will then copy and paste the code below into the settings.json and click save: | ||
+ | |||
+ | this would be for **Node 1** matching the port forwarding entry above: | ||
< | < | ||
" | " | ||
" | " | ||
+ | }</ | ||
+ | |||
+ | this would be for **Node 2** matching the port forwarding entry above: | ||
+ | |||
+ | < | ||
+ | " | ||
+ | " | ||
+ | }</ | ||
+ | |||
+ | this would be for **Node 3** matching the port forwarding entry above: | ||
+ | |||
+ | < | ||
+ | " | ||
+ | " | ||
+ | }</ | ||
+ | |||
+ | this would be for **Node 4** matching the port forwarding entry above: | ||
+ | |||
+ | < | ||
+ | " | ||
+ | " | ||
}</ | }</ | ||