User Tools
qortal_ui
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| qortal_ui [08/03/2021 20:20] – gfactor | qortal_ui [08/06/2021 22:37] – gfactor | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Qortal UI ====== | ====== Qortal UI ====== | ||
| + | {{: | ||
| **The core auto updates. At the moment, the UI does not auto update. Updating the UI is simple.** | **The core auto updates. At the moment, the UI does not auto update. Updating the UI is simple.** | ||
| Line 11: | Line 12: | ||
| For Raspberry Pi: Open your device’s command terminal and enter: run ./ | For Raspberry Pi: Open your device’s command terminal and enter: run ./ | ||
| - | You will then press ‘y’ a couple of times and the update will start. It will take several minutes, even appearing to not be doing anything at times. Wait for it to completely finish. It will finish with a confirmation message: “BUILD COMPLETE! You can now make use of the new UI!" You can then close the terminal. | + | You will then press ‘y’ a couple of times and the update will start. It will take several minutes, even appearing to not be doing anything at times. Wait for it to completely finish. It will finish with a confirmation message: “BUILD COMPLETE! You can now make use of the new UI!" You can then close the terminal. |
| **Where do I find my public key and address? | **Where do I find my public key and address? | ||