This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
qortector_commands [11/25/2021 17:06] – gfactor | qortector_commands [11/25/2021 17:18] – gfactor | ||
---|---|---|---|
Line 2: | Line 2: | ||
{{: | {{: | ||
- | Below is a walkthrough of your QORTector and a list of commands you can use within the Terminator for various purposes. Terminator is located in the taskbar with an icon that looks like this: | + | **This page is work in progress (started 11/25/21 and will be updated shortly).** |
- | {{:: | + | |
+ | {{: | ||
===== Start & Stop QORTector ===== | ===== Start & Stop QORTector ===== | ||
- | The QORTector is setup to automatically start the core when you turn on the device. **You should always command the core to shut down within the Terminal prior to turning off the device to avoid corrupting the database. Make sure to cancel all trade within the Trade Portal before doing so.** | + | The QORTector is setup to automatically start the core when you turn on the device. **You should always command the core to shut down within |
- | To stop the core, open Terminal, | + | **To stop the core:** open Terminator |
< | < | ||
./ | ./ | ||
- | It will then say ' | + | It will then say ' |
{{:: | {{:: | ||
- | To start the core, open Terminal, | + | **To start the core:** open Terminator |
< | < | ||
./ | ./ | ||
- | It will then say ' | + | It will then say ' |
{{:: | {{:: | ||
+ | You will then see the Qortal Core startup indication: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | **To stop and start the core in one window:** open Terminator and enter the following separately: | ||
+ | |||
+ | < | ||
+ | ./stop.sh | ||
+ | ./ | ||
+ | Below is a screenshot of the entire process: | ||
+ | |||
+ | {{:: | ||
+ | |||
+ | You will then see the Qortal Core startup indication: | ||
+ | |||
+ | {{: |