This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
qortector_plumbus_3.0.4_update_guide [01/29/2022 20:33] – gfactor | qortector_plumbus_3.0.4_update_guide [01/29/2022 20:35] – gfactor | ||
---|---|---|---|
Line 8: | Line 8: | ||
{{:: | {{:: | ||
- | {{:333afd4b-0503-4b18-a8ab-1e25bd34b914.jpeg?400|}} | + | |
+ | When using the appimage you NO LONGER NEED the previous start script that you used to use to start the UI, you can REMOVE that start script. | ||
+ | |||
+ | You can add the Qortal icon to the appimage file - by right clicking on the appimage file, going to properties then clicking the icon, it will open up a browse, and you can find the Qortal UI icon in the ```UI/ | ||
+ | |||
+ | (This is mostly for QORTector users, or anyone who setup their system in a similar fashion, with the Start-Qortal-UI-Electron.sh script that @crowetic wrote. That script, as well as the update script, are no longer needed if you use the new appimage. The appimage is literally an image of the Qortal UI application, | ||
+ | |||
+ | To re-iterate and avoid confusion - You do NOT need the previous ' | ||
+ | |||
+ | You run the appimage file directly, after making it executable. | ||
2) Enter this command in terminal to update the stop script if you haven’t already: | 2) Enter this command in terminal to update the stop script if you haven’t already: |