User Tools
how_to_orphan_back
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| how_to_orphan_back [05/06/2021 10:38] – thesudio | how_to_orphan_back [02/23/2022 01:48] (current) – removed gfactor | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== How To Orphan Back ====== | ||
| - | This page is under construction! | ||
| - | |||
| - | Ditch chain to set height: | ||
| - | |||
| - | If your core is stuck at some height, you can try to ditch blocks to some height and re-sync from there. You are inputting height to ditch to. If you will input 300000, your core will drop blocks up to 300000 and then start to sync from that height and catch back up to the right height. If during the roll back you notice its getting slower or stalling, just close core and repeat steps, sometimes you need to repeat the steps a couple to roll back to your desired block quickly: | ||
| - | |||
| - | http:// | ||
how_to_orphan_back.1620311919.txt.gz · Last modified: 05/06/2021 10:38 by thesudio