This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
how_to_reduce_bandwidth [12/07/2022 15:00] – [Enabling Top-Only Mode] gfactor | how_to_reduce_bandwidth [05/22/2023 14:49] (current) – quickmythril | ||
---|---|---|---|
Line 18: | Line 18: | ||
===== How To Reduce Peers ===== | ===== How To Reduce Peers ===== | ||
- | The most significant factor is your peer settings. **Please note:** this modification should be what most users will need to reduce bandwidth. All other sections that follow are not really necessary, but can be considered. You can reduce peers as follows: | + | The most significant factor is your peer settings. **Please note:** this modification should be what most users will need to reduce bandwidth. All other sections that follow are not really necessary, but can be considered |
+ | |||
+ | You can reduce peers as follows: | ||
< | < | ||
- | “minBlockchainPeers": | ||
" | " | ||
}</ | }</ | ||
- | |||
===== Disabling Relay Mode ===== | ===== Disabling Relay Mode ===== | ||
- | Data can be relayed through our nodes, in order for other nodes to communicate. All of this data is end-to-end encrypted, and is also chunked so the data is not relayed on a single node. The data being relayed is only on your node long enough to conduct the transfer, and is deleted afterwards automatically. Users can choose to opt out of relay mode if their lack of understanding with this matter raises too much concern. Getting data around the network is difficult and requires more fine tuning- even with relay mode enabled (which helps the network). You can read more about this topic on the [[Qortal Data Network (QDN)]] page. To disable relay mode, add this setting to your json settings: | + | Data can be relayed through our nodes in order for other nodes to communicate. All of this data is end-to-end encrypted, and is also chunked so the data is not relayed on a single node. The data being relayed is only on your node long enough to conduct the transfer, and is deleted afterwards automatically. Users can choose to opt out of relay mode if their lack of understanding with this matter raises too much concern. Getting data around the network is difficult and requires more fine tuning - even with relay mode enabled (which |
+ | |||
+ | If you want to disable relay mode to further reduce your bandwidth, add this setting to your json settings: | ||
< | < | ||
Line 40: | Line 42: | ||
===== All Of The Above Settings===== | ===== All Of The Above Settings===== | ||
- | Below is how to add all of the above to your json settings (this would include disabling QDN which is the most extreme setup for users with limited data service): | + | Below is how to add all of the above to your json settings (this would include disabling |
< | < | ||
- | “minBlockchainPeers": | ||
" | " | ||
- | "topOnly": | + | " |
- | “relayModeEnabled": | + | |
" | " | ||
}</ | }</ | ||
Line 56: | Line 56: | ||
Additionally, | Additionally, | ||
- | {{::img_8675.jpg?400|}} | + | {{::81c28b26-3625-4052-ae67-228ea4bad933.jpeg?400|}} |