This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
qortector_commands [11/25/2021 17:08] – gfactor | qortector_commands [11/25/2021 19:23] (current) – removed gfactor | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== QORTector Walkthrough ====== | ||
- | {{: | ||
- | |||
- | Below is a walkthrough of your QORTector and a list of commands you can use within the Terminator for various purposes. Terminator is located in the taskbar with an icon that looks like this: | ||
- | |||
- | {{:: | ||
- | |||
- | |||
- | ===== Start & Stop QORTector ===== | ||
- | |||
- | The QORTector is setup to automatically start the core when you turn on the device. **You should always command the core to shut down within the Terminator (also referred to as the Terminal) prior to turning off the device to avoid corrupting the database. Make sure to cancel all trade within the Trade Portal before doing so.** | ||
- | |||
- | To stop the core, open Terminator, and enter the following separately: | ||
- | |||
- | < | ||
- | ./ | ||
- | It will then say ' | ||
- | |||
- | {{:: | ||
- | |||
- | To start the core, open Terminator, and enter the following separately: | ||
- | |||
- | < | ||
- | ./ | ||
- | It will then say ' | ||
- | |||
- | {{:: | ||