This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
qortal_ui [08/03/2021 14:26] – gfactor | qortal_ui [12/23/2022 12:13] (current) – removed gfactor | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Qortal UI ====== | ||
- | **Updating the UI is simple.** Open your device’s command terminal and enter: run ./ | ||
- | |||
- | You will then press ‘y’ a couple of times and the update will start. It will take several minutes, even appearing to not be doing anything at times. Wait for it to completely finish. It will finish with a confirmation message. It will be obvious when it has completed the update before you can close the terminal. | ||
- | |||
- | **Where do I find my public key and address? | ||
- | In the UI, there' | ||
- | |||
- | **Does anyone know why a level 5 account from QORA wouldn' | ||
- | I'm receiving rewards from my previous QORA holdings, but it says 'not minting' | ||
- | |||
- | **If I have a minting enabled account, should I reward share myself with share percent of 100%? | ||
- | No. Keep reward share at 0% because this is a self share. Reward Share is when you sponsor people and you decide to share your reward with them, so set it to whatever percentage you want to share (if you desire). | ||
- | |||
- | **Guide on how to assign minting key:** | ||
- | |||
- | {{: | ||
- | |||
- | ASSIGN MINTING KEY IN DETAILS | ||
- | |||
- | Go to [[Becoming a minter]] and the ‘How To Become A Minter After 7200 Blocks’ section. |