User Tools
pre-configured_qortector_setup
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| pre-configured_qortector_setup [08/16/2021 20:53] – gfactor | pre-configured_qortector_setup [08/17/2022 23:09] (current) – removed gfactor | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Pre-Configured QORTector Setup ====== | ||
| - | {{:: | ||
| - | |||
| - | Below are the steps for setting up your pre-configured QORTector: | ||
| - | |||
| - | **Important: | ||
| - | |||
| - | Basically plug everything in, configure wifi if you’re not using Ethernet, let it sync. | ||
| - | |||
| - | Login is username: Pi | ||
| - | Default password: dmax911e | ||
| - | |||
| - | To change password, open terminal and enter: passwd | ||
| - | |||
| - | Then enter your new password! | ||
| - | |||
| - | Add your account with your backup file (http:// | ||
| - | |||
| - | Here are two videos Crowetic made for setup: | ||
| - | |||
| - | https:// | ||
| - | |||
| - | https:// | ||
| - | |||
| - | If your device doesn’t have latest UI version, open terminal, run this command: | ||
| - | ./ | ||
| - | |||
| - | (Press ‘y’ and ‘enter’ the couple of times as prompted. It may ask you a few times to delete a few files - just enter ‘y’ and proceed. The update will begin. It may appear that nothing is happening but be patient and wait for the ‘BUILD COMPLETE’ message. This is confirmation that the update is finished which you can then close the terminal! | ||
| - | |||
| - | Always tell QORTector to shut down from the menu option, don’t use the power switch. Power switch should only be shut off after the device powers down to protect it from surges, but with that said, you should have a surge protector or UPS (battery power supply) regardless as the QORTector is intended to stay running 24/7. | ||
pre-configured_qortector_setup.1629161613.txt.gz · Last modified: 08/16/2021 20:53 by gfactor