Below are the steps for setting up your pre-configured QORTector:

Important: Do NOT run the QORTector if fan isn’t running after powering the device! The fan needs to be running to prevent the board from overheating.

Basically plug everything in, configure wifi if you’re not using Ethernet, let it sync.

Login is username: Pi Default password: dmax911e

To change password, open terminal and enter: passwd

Then enter your new password!

Add your account with your backup file (http://wiki.qortal.org/doku.php?id=account_recovery_backup_file).

Here are two videos Crowetic made for setup:

https://youtu.be/9cIEpAq_j6E

https://youtu.be/Z6cERzvPGR0

If your device doesn’t have latest UI version, open terminal, run this command: ./update-qortal-ui.sh

(Press ‘y’ and ‘enter’ the couple of times as prompted. It may ask you a few times to delete a few files - just enter ‘y’ and proceed. The update will begin. It may appear that nothing is happening but be patient and wait for the ‘BUILD COMPLETE’ message. This is confirmation that the update is finished which you can then close the terminal!

Always tell QORTector to shut down from the menu option, don’t use the power switch. Power switch should only be shut off after the device powers down to protect it from surges, but with that said, you should have a surge protector or UPS (battery power supply) regardless as the QORTector is intended to stay running 24/7.