Qortal Project

The future of blockchain platforms

User Tools

Site Tools


Sidebar

Qortal Project Wiki

Important Notices

Introduction

Project Model

Minting

Communications

Trade Portal

Qortal Hosting (QDN)

Voting System

AT System

Hardware

Frequently Asked Questions (FAQ)

How-To Guides

Node Setup Guides

Third-Party Services

how_to_orphan_back

This is an old revision of the document!


How To Orphan Back

This page is under construction!

Ditch chain to set height:

If your core is stuck at some height, you can try to ditch blocks to some height and re-sync from there. You are inputting height to ditch to. If you will input 300000, your core will drop blocks up to 300000 and then start to sync from that height and catch back up to the right height. If during the roll back you notice its getting slower or stalling, just close core and repeat steps, sometimes you need to repeat the steps a couple to roll back to your desired block quickly:

http://localhost:12391/api-documentation/#/Admin/orphan

how_to_orphan_back.1628303893.txt.gz · Last modified: 08/06/2021 22:38 by gfactor