Updating the UI is simple. Open your device’s command terminal and enter: run ./update-qortal-ui.sh

You will then press ‘y’ a couple of times and the update will start. It will take several minutes, even appearing to not be doing anything at times. Wait for it to completely finish. It will finish with a confirmation message. It will be obvious when it has completed the update before you can close the terminal.

Where do I find my public key and address? In the UI, there's an info symbol ( :gear: ) in the top right corner. Click on the symbol, then you will see your public key and address.

Does anyone know why a level 5 account from QORA wouldn't be minting? I'm receiving rewards from my previous QORA holdings, but it says 'not minting'. You must sponsor yourself by entering your public key into Reward Share, then entering the Reward Share key into the Node Management section where you “Add Minting Account”. QORA 20% block reward is earned automatically without having to mint. If you wish to mint, in this case, your level 5 account would ALSO earn the portion of block reward for the level 5+6 tier (on top of your QORA 20%).

If I have a minting enabled account, should I reward share myself with share percent of 100%? No. Keep reward share at 0% because this is a self share. Reward Share is when you sponsor people and you decide to share your reward with them, so set it to whatever percentage you want to share (if you desire).

Guide on how to assign minting key:

ASSIGN MINTING KEY IN DETAILS

Go to Becoming A Minter and the ‘How to become a minter after 7200 blocks’ section.